Install a 240 V, 50 A EV charger circuit in garage (with option of 2nd circuit)

Open
Minneapolis More than 2 weeks Posted
3 providers biddingLowest fixed-price bid $1,685

What needs to be done

Project Description: Looking for a licensed, insured electrician to install a dedicated 240-volt, 50-amp circuit in my attached garage for a ChargePoint Home Flex Level 2 EV charger (EVSE).

Current bids (3)

You don't have to be the cheapest to win!

A great proposal, experience, reviews, and availability can make your bid stand out, even at a higher price.

  • Pro 65No reviews yet
    Lowest fixed-price bid
    $1,685.00Flat price
    1 additional option
  • Pro 20 169 reviews
    $2,125.00Flat price
  • Pro 83No reviews yet
    $12,000.00Flat price

Bid prices and basic provider ratings are public. Identity, proposals, and contact details stay private from other pros.

Job details

Service
Electrical
ZIP code
55407
Requested circuit voltage
240 V
Requested circuit amperage
50 A
How should the charger connect?
Not sure
Does the electrical panel have room for a new breaker?
Yes
About how far is it from the electrical panel to the charger location
35 ft
Location
Minneapolis
Timing
More than 2 weeks

Other details

Current Setup & Details:

• Electrical Service: 200-amp Square D QO main panel located in the basement with open breaker spaces available. (Range, dryer, furnace, and water heater are all natural gas, leaving ample panel capacity).

• Routing Access: The basement ceiling is unfinished open joists, though access above the panel and along the foundation wall is somewhat tight due to existing conduit and HVAC ductwork (see attached photos). The approximate wire run from the panel to the target garage wall is 30 to 40 feet.

• Wiring Method: Surface-mounted conduit (EMT/PVC) inside the garage (and along the basement ceiling/wall if needed to clear ductwork) is completely fine—no drywall cutting or concealment needed. Target Installation (Please Quote Primary Options + Optional Add-On):

• Option A (Hardwired): Dedicated 240V, 50A circuit hardwired directly into a ChargePoint Home Flex EVSE mounted roughly 4 feet off the garage floor.

• Option B (Plug-In Outlet): Dedicated 240V, 50A circuit terminating in a NEMA 14-50 receptacle mounted roughly 4 feet off the garage floor (to power a plug-in ChargePoint Home Flex).

• Optional Add-On (Future 2nd EV): Please also provide a separate line-item price to run a second dedicated 240V, 50A circuit (either complete with a second NEMA 14-50 outlet or capped in a junction box for future use) along the same path while on-site. Requirements for Bids:

• Please include all labor, materials, and the required electrical permit/inspection in your quote.

• For the NEMA 14-50 option, quote must include an industrial/EV-grade receptacle (such as Hubbell or Bryant—no standard builder/dryer-grade outlets) and a GFCI-protected breaker per current NEC code.

• Please confirm your electrical license number and insurance status when bidding. I have attached photos of my main panel (with the door open), the tight overhead clearance and ductwork path in the basement, and the exact spot on the garage wall where I want the charger/outlet placed. Once you post this with your photos and get a few bids back, feel free to share the quote breakdowns here so I can help you compare labor, materials, and permit inclusions across the electricians!

Public questions & answers0

Ask about the job. Answers help everyone understand what’s needed.

No questions yet

Have a question about the work? Ask it here.

BidGreat supportChat with us about BidGreat